Practical research · 9 September 2026

UV Ink Adhesion Testing: A Small-Batch Test Log

A print can look crisp and still peel from the blank. Before accepting a production order, test the exact blank, ink and preparation method together. This guide provides a small-batch comparison plan; it does not certify dishwasher safety, food-contact suitability or compliance with a formal adhesion standard.

Separate the finish from the bond

Adhesion describes how well the ink stays attached to the substrate. Scratch resistance describes what happens when the printed surface is abraded. They are related ownership concerns, but a successful check of one does not establish the other. Decide which failure would make your customer reject the item before deciding what to measure.

Roland describes cross-hatch and tape testing for UV ink adhesion. Its primer guidance also recommends testing the proposed substrate and ink combination before production. Use the printer maker's procedure, compatible consumables and safe handling instructions. An improvised tape pull should be described as an internal comparison, not as a certified test.

Source: Roland DG: testing UV ink adhesion

Make the comparison useful

Choose blanks from the same shipment and keep the artwork, print mode and handling consistent. Label each sample before you prepare it. Include your usual preparation as a control; compare one proposed change at a time, such as a compatible primer recommended for that substrate. Changing primer, ink mode and blank supplier together leaves you unable to explain the result.

Write down the cleaner and preparation sequence, but do not assume one solvent suits every plastic or coating. Ask the blank supplier about chemical compatibility and test on a spare part. Use the maker's required waiting or curing conditions. Record actual elapsed time instead of writing only 'tested next day'.

Source: Roland DG: primer and substrate compatibility

Use a log that someone else can repeat

The following worksheet is an editorial planning tool. It deliberately records both the specimen and the decision. Photograph the same printed area before and after each check, in similar light, with the sample label visible. Keep an untested reference from the batch so later handling damage is distinguishable from an original print defect.

Use a log that someone else can repeat
RecordExample of a useful entry
Sample identityBlank SKU, supplier, batch and sample A/B
ProcessPrinter, ink set, mode, cleaning and primer
TimingPrinted time; test time; storage conditions
ObservationWhere ink lifted; photograph filename
DecisionPass for this use, repeat, or reject; reason

Turn observations into a production decision

If the control and changed sample both fail, stop and check substrate compatibility with the supplier before buying another machine. If only one preparation works, repeat that process on additional blanks. A single good sample is encouraging, but it does not establish consistency across a shipment.

Run separate use-relevant checks for rubbing, packaging contact or washing, using documented conditions. Avoid extending the result to boiling water, dishwashers or food-contact surfaces without appropriate evidence. Save the approved sample and the work instructions with the order. Repeat the comparison when the blank coating, ink, primer or print process changes; a familiar product name is not a guarantee of identical materials.

Continue your research